User's Manual

System Installation
P/N 709C010701
Page 22
3 System Installation
This chapter describes the installation procedure for the MobileAccessGX-Quad Remote Units.
The installation of the system components must be in the following order:
1. External Filter installation - only relevant for GX-Quad models supporting CELL band and
which are deployed with units supporting 800 MHz band. See section 3.1.
2. External Combiner installation (optional). See section 3.2.
3. GX-Quad Installation. See section 3.3.
3.1
Installing External Filter (If Required)
An external filter is required if GX-Quad remote unit supporting the CELL band is deployed
along with units supporting the 800MHz band.
NOTE: The External Filter is not supplied with the GX unit and must be ordered separately.
1. Mount the External Filter on the side of the GX-Quad remote unit using the filter bracket so
that the Input and Output connectors face the direction of the GX-Quad panel connectors.
2. Remove the jumper cable from the GX-Quad filter In/Out connectors and connect to
corresponding External Filter connections.
GX-Quad Filter Connectors
Figure 3-1