User's Manual

RF Safety
P/N 709C010701
Page 6
RF Safety
NOTE: Keep all packing material until you have completed the inspection
WARNING! To comply with FCC RF exposure compliance requirements, each individual antenna used for this
transmitter must be installed to provide a separation distance greater than 160 cm or more from all persons during
normal operation and must not be co-located with any other antenna for meeting RF exposure requirements. The
design of the antenna installation needs to be implemented in such a way so as to ensure RF radiation safety levels
and non-environmental pollution during operation.
WARNING! Antenna gain should not exceed 12.5 dBi.
WARNING! The design of the antenna installation needs to be implemented in such a way so as to ensure RF
radiation safety levels and non-environmental pollution during operation.
Compliance with RF safety requirements:
 Corning MobileAccess products have no inherent significant RF radiation.
 The RF level on the downlink is very low at the downlink ports. Therefore, there is no dangerous RF radiation
when the antenna is not connected.