User's Manual
Table Of Contents
- Preface Material
- Policy for Warrantee and Repair
- Safety Instructions
- Warnings and Admonishments
- Standards and Certification
- About this Guide and Other Relevant Documentation
- Table of Contents
- 1 Introduction to GX System
- 2 System Installation
- 3 Commissioning MA Head-End
- 4 Provisioning the MobileAccessGX
- Appendix A: System Specifications
- Appendix B: Ordering Information
- Appendix C: Site Preparation
MobileAccessGX Installation and Configuration Guide 10
2.4 Assembling Radome on GX – TBD
Radome (optional) must be assembled before the unit is mounted.
2.5 Installing the GX Unit
2.4.1 Unpacking and Inspection
Unpack and inspect the cartons according to the following procedure
1. Open the shipping carton and carefully unpack each unit from the protective packing
material.
2 Please verify that the items listed below are included in your package (image size is not
proportional):
Item
Qty.
Image
MobileAccessGX Remote Unit
1
Mounting Brackets and loosely assembled:
Nuts M8, Spring Washers Φ8, Plain
Washers Φ8 (used for securing Remote
Unit when hanged on bracket protrusions)
2
3 (per bracket)
Masonry Bolt (set) M10x110 – used for
wall
mount
installations
4
2 (per bracket)
Hose Clamp (Φ30-Φ125) - used for
pole
mount
installations (2 per bracket)
4
Optical Connector
2
-