User's Manual
Table Of Contents
- Preface Material
- Policy for Warrantee and Repair
- Safety Instructions
- Warnings and Admonishments
- Standards and Certification
- About this Guide and Other Relevant Documentation
- Table of Contents
- 1 Introduction to GX System
- 2 System Installation
- 3 Commissioning MA Head-End
- 4 Provisioning the MobileAccessGX
- Appendix A: System Specifications
- Appendix B: Ordering Information
- Appendix C: Site Preparation
MobileAccessGX Installation and Configuration Guide 31
3.5 OCH Configuration Dialog
The configuration dialog consists of two tabs: Module Info and RF parameters. The main
provided functions are:
In the Module Info tab - Viewing basic information on the unit and assigning the unit an
identifiable name.
In the RF Parameters tab - Setting gain control, resetting the Base Unit (required when an
RHU is added) and monitoring the downlink signal.
To Configure and Control the OCH (Optical Control Hub) Unit:
1. Double-click on the OCH item in the Network Topology. The Base Unit configuration
dialog appears.
Figure 3-14: Base Unit Module Info Tab
2. (Optional) In the Module Info tab click the Modify button and assign the OCH an
identifiable name that indicates the technology to which it interfaces.
3. Click on the host OCH unit item and verify that all of the alarms in the OCH Alarms display
area are GREEN (refer to
SC-450 User Manual
for detailed description of alarms).
Selected OCH
unit