User's Manual
Table Of Contents
- Preface Material
- Policy for Warrantee and Repair
- Safety Instructions
- Warnings and Admonishments
- Standards and Certification
- About this Guide and Other Relevant Documentation
- Table of Contents
- 1 Introduction to GX System
- 2 System Installation
- 3 Commissioning MA Head-End
- 4 Provisioning the MobileAccessGX
- Appendix A: System Specifications
- Appendix B: Ordering Information
- Appendix C: Site Preparation
MobileAccessGX Installation and Configuration Guide 37
3. Assign the unit a recognizable name (i.e. corresponding to its location):
In the Module Info tab, click the Modify button, enter the required text and click OK. The
assigned name will be displayed.
Figure 4-4: GX Module Info Tab
4. Click the RF Parameters tab.
Figure 4-5: GX RF Parameters Tab
Verify the following:
All required services (e.g. Cell, AWS, etc.) are enabled (Default = On)
Define UL and DL gain attenuation.
Click Modify and
assign name
Services enabled
User defined name