User's Manual
Table Of Contents
- Warranties
- Hardware
- Software Warranty
- Returns
- Limitations of Liabilities
- Reporting Defects
- Warnings and Admonishments
- RF Safety
- Compliance with RF safety requirements:
- Power requirements for DC Inputs
- Laser Safety
- Care of Fiber Optic Connectors
- Regulatory Compliance Information
- Standards and Certifications
- Licensee Contact Information
- About this Guide
- Additional Relevant Documents
- List of Acronyms
- Table of Contents
- 1 Introduction
- 2 Installation Guidelines
- 3 Physical Installation
- Appendix A: System Specifications
- RF Parameters
- Supported Services
- RF Parameters per Service Antenna Port
- RF Adjustment
- OverPower Protection Mechanism
- Power Down Mechanism
- RF Parameters for External Wideband and WCS Input Ports
- Physical Specifications
- Standards and Approvals
- Appendix B: Ordering Information
Corning Restricted - Draft for public release
Introduction
CMA-xxx-AEN
Page 14
Figure 1-4 shows an example of MIMO scenarios in a system topology where the HX 2.5 GHz TDD is connected to
existing HX4 and MA2000 QX remotes. The HX 2.5 GHz TDD remote is installed between the existing remote unit (e.g.
HX, MA2000 QX) and the optical converter unit (i.e. OCH) and interfaces them both via fiber connections. MIMO
configurations require one line of fiber for each MIMO stream and one EPM for each stream in installations with
MA1000/MA2000 remotes.
HX 2.5 GHz TDD – MIMO Architecture with an existing HX4 and MA2000 QX, Sharing a Common
Headend
Figure 1-3