User's Manual
Table Of Contents
- Warranties
- Hardware
- Software Warranty
- Returns
- Limitations of Liabilities
- Reporting Defects
- Warnings and Admonishments
- RF Safety
- Compliance with RF safety requirements:
- Power requirements for DC Inputs
- Laser Safety
- Care of Fiber Optic Connectors
- Regulatory Compliance Information
- Standards and Certifications
- Licensee Contact Information
- About this Guide
- Additional Relevant Documents
- List of Acronyms
- Table of Contents
- 1 Introduction
- 2 Installation Guidelines
- 3 Physical Installation
- Appendix A: System Specifications
- RF Parameters
- Supported Services
- RF Parameters per Service Antenna Port
- RF Adjustment
- OverPower Protection Mechanism
- Power Down Mechanism
- RF Parameters for External Wideband and WCS Input Ports
- Physical Specifications
- Standards and Approvals
- Appendix B: Ordering Information
Corning Restricted - Draft for public release
Physical Installation
CMA-XXX-AEN
Page 34
3. Referring to bracket hole dimensions in Figure 3-6 (units in mm), prepare the appropriate anchors and mount
as follows:
• Mark four holes (minimum of two on per bracket) on the wall for drilling the anchors
• Drill four holes, using a hammer drill.
• Fill the holes with silicon to help weather-proof the drilled holes and to prevent erosion.
• Tap in expanding lead shield anchors
Wall-Mount Bracket Hole Dimensions
Figure 3-6
4. Insert two bolts in top anchors and tighten until bolt head is 0.5-in from surface of wall. See Figure
3-7.
Inserting First two Bolts in Anchors
Figure 3-7