User's Manual
Table Of Contents
- Warranties
- Hardware
- Software Warranty
- Returns
- Limitations of Liabilities
- Reporting Defects
- Warnings and Admonishments
- RF Safety
- Compliance with RF safety requirements:
- Power requirements for DC Inputs
- Laser Safety
- Care of Fiber Optic Connectors
- Regulatory Compliance Information
- Standards and Certifications
- Licensee Contact Information
- About this Guide
- Additional Relevant Documents
- List of Acronyms
- Table of Contents
- 1 Introduction
- 2 Installation Guidelines
- 3 Physical Installation
- Appendix A: System Specifications
- RF Parameters
- Supported Services
- RF Parameters per Service Antenna Port
- RF Adjustment
- OverPower Protection Mechanism
- Power Down Mechanism
- RF Parameters for External Wideband and WCS Input Ports
- Physical Specifications
- Standards and Approvals
- Appendix B: Ordering Information
Corning Restricted - Draft for public release
Physical Installation
CMA-XXX-AEN
Page 36
Unpack and inspect the carton as follows:
1. Open the shipping carton and carefully unpack each unit from the protective packing material.
2. Verify that all of the items required for wall mount installation have been received (refer to Table
3-2). If any of
the listed items are missing, contact your Corning representative.
3. Check for signs of external damage. If there is any damage, call your Corning service representative.
Wall Mount Bracket (Back-to-Wall) Assembly
Kit
Quantity
Bracket
2
(RT/LT)
Pan Head Screw Sems UNC 6-32, 12 mm;
Stainless Steel; Used for securing bracket to HX
sides
16
Table 3-2. HX 2.5 GHz TDD Wall-Mount Brackets Package Items List
Additional required tools and materials
• Philips/electric screwdriver
• Hammer drill
• Two anchors for hanging brackets on wall (anchor type depends on surface type) and four bolts for secure
installation