User's Manual
Table Of Contents
- Warranties
- Hardware
- Software Warranty
- Returns
- Limitations of Liabilities
- Reporting Defects
- Warnings and Admonishments
- RF Safety
- Compliance with RF safety requirements:
- Power requirements for DC Inputs
- Laser Safety
- Care of Fiber Optic Connectors
- Regulatory Compliance Information
- Standards and Certifications
- Licensee Contact Information
- About this Guide
- Additional Relevant Documents
- List of Acronyms
- Table of Contents
- 1 Introduction
- 2 Installation Guidelines
- 3 Physical Installation
- Appendix A: System Specifications
- RF Parameters
- Supported Services
- RF Parameters per Service Antenna Port
- RF Adjustment
- OverPower Protection Mechanism
- Power Down Mechanism
- RF Parameters for External Wideband and WCS Input Ports
- Physical Specifications
- Standards and Approvals
- Appendix B: Ordering Information
Corning Restricted - Draft for public release
Physical Installation
CMA-XXX-AEN
Page 42
3.3.1.2 RF Connections to HX WCS
1. Perform the WCS service connections as follows:
Connect From Port… To Port…
Unit:
HX 2.5 GHz TDD
Unit:
HX WCS
Port Name: WCS RU Port Name: ANT
Port Type: Mini DIN 4.3-10 Type duplexed Port Type: Mini DIN 4.3-10 Type duplexed
Table 3-4. WCS Service Connection
Note: For SISO installations the connections are from HX 2.5 GHz TDD ANT 1 (MUX) “WCS RU” port to the HX WCS
ANT 1 (MUX) “ANT” port; For MIMO installations the MIMO 2 Stream connections are performed between the HX 2.5
GHz TDD ANT 2 (MUX) “WCS RU” port and the HX WCS ANT 2 (MUX) “ANT” port.
RF Connections Between HX 2.5 GHz and Existing HX-WCS (Right-SISO;Left – MIMO)
Figure 3-14