User's Manual
Table Of Contents
- Warranties
- Hardware
- Software Warranty
- Returns
- Limitations of Liabilities
- Reporting Defects
- Warnings and Admonishments
- RF Safety
- Compliance with RF safety requirements:
- Power requirements for DC Inputs
- Laser Safety
- Care of Fiber Optic Connectors
- Regulatory Compliance Information
- Standards and Certifications
- Licensee Contact Information
- About this Guide
- Additional Relevant Documents
- List of Acronyms
- Table of Contents
- 1 Introduction
- 2 Installation Guidelines
- 3 Physical Installation
- Appendix A: System Specifications
- RF Parameters
- Supported Services
- RF Parameters per Service Antenna Port
- RF Adjustment
- OverPower Protection Mechanism
- Power Down Mechanism
- RF Parameters for External Wideband and WCS Input Ports
- Physical Specifications
- Standards and Approvals
- Appendix B: Ordering Information
Corning Restricted - Draft for public release
Appendix A: System Specifications
CMA-XXX-AEN
Page 52
Appendix A: System Specifications
RF Parameters
Supported Services
Frequency Range
Technologies Band Uplink and Downlink (Combined)
LTE* 2500 2.5 GHz 2496-2690 MHz
* LTE compiles with 3GPP TS 36.106 V10.6.0 (2012-12) table 9.1 unwanted emission.
RF Parameters per Service Antenna Port
LTE2500 TDD
RF Parameters DL UL
Max Output Power Per Antenna
Port
1 Operator (Composite)
3
(dBm) 33
2 Operators(dBm) 30
4 Operators(dBm) 27
8 Operators(dBm) 24
Mean Gain (dB)
1
33 31
Pin
1
(dBm) 0
Input IP3 (dBm) AGC OFF
Typical
-13
Max. Intermod Distortion (dBm) -13
NF (dB) Typical
6
RF Output Port Impedance 50 ohm
Gain Flatness/Ripple (dB)
2
+/- 1.5
Output Power Controll range 19 ~ 34dBm
1
Factory set mean gain OCH without RIU. May be field adjusted using controller system.
2
Gain Flatness/Ripple is specified for the non-duplexed port of the system.