User's Manual

User Manual v1.0
Corning Restricted and Confidential Proprietary - Controlled content
BWS Draft2 LPR UM - 29-DEC-2019| September 2019 |Page 16 of 29
1.4 Key Features and Capabilities
Flexible and economic traffic management; Optimized network utilization:
A unique combination of smart traffic management techniques, allowing load (and thus cost) reduction
based. These optimizations are achieved via automated management considerations and path selection
techniques. e.g.: Dynamic routing (from each vBBU port to each remote port and vice versa); Advanced
clusterization logic (up to 24 clusters; allows downlink forking and then uplink summing, to reduce CPRI
throughput); capacity steering techniques, and more.
Economic and simplified upgrade scenario; Easy and flexible installation & software upgrade;
Simple & fast deployment
FPGA programmable system, avoiding the need to replace hardware for standard software upgrades;
Supports remote connection for software upgrade and management
Easy-to-use ethernet management & remote access
Easy and friendly administrator and operator tools (two administration connections: LAN for management
and Local for debug); indication LEDs;
Support for up to 100 Mbps for management over CPRI fast C&M channel transport for each CPRI port
Reordering (agnostic packet order)
Flexible CPRI routing; allocation of incoming channel in any AxC location on the CPRI stream
Start-up and Upgrade recovery control mechanisms
Hot swap; CPRI “Plug and Play”. Only 10.1 Gbps (CPRI option 8) SW/HW/clock failure recovery mechanism.
Free digital platform, providing cost-effective and highly reliable services
Fully digital based unit: less noise, reducing power loss (attenuation/amplification) and reducing cost.
Support for 4G and 5G
Technology agnostic
Frequency scalability
Wide coverage for RF channels; additional frequencies without HW replacement. Supported frequencies: 5
MHz, 10 MHz, 15 MHz, 20 MHz
Acoustic noise
Validated per GR-63
Modular input power
Support for AC and for DC power IN
Scalability of unit connectivity
BBUs: Up to four high capacity sources per DRU
Remotes: Up to 32 low power units per DRU
DRUs: Up to four DRUs connected per BBU
Synchronization: 10 MHz clock domain