Instruction Manual

ATT (DB) MIMO in turn. When MI MO i s set to MIMO 1, it mean s that the
carrier signal outputs a signal from the ANT1 port of dLRU, Setting MIMO
to MIM O 2 means that the carrier signal outputs the signal from the ANT2
port o f dLRU . After the configuration is co mpleted, click Finish to complete
the carrie r configura ti on.
Figure 6.3-2 carrier configuration page
To realize the carrier output signal from channel 1 SISO of dLRU , the
confi guration informa tion is shown in the f igure. The con figuration range
of UL Center Freq . (M Hz) and DL Center Freq. (MHz) is 3450 ~3700. In this
example, 3575M is configured, and the MIMO mode is set to MIMO 1.