User's Manual

User Manual v1.0
UM - Everon 6000 DAS - 1-MAR-2021 - clear of comments| March 2021 |Page 35 of 174
2.2.4 Install the Modules in the Chassis
Note: For modules with ejectors (i.e. RIM, RIX OIM, OIX, DCM and HCM/ACM) – verify that the
ejectors are completely open when inserting in dedicated slot and then push in until the module
clicks in to the backplane. See Figure 5: Module Captive Screws and Ejectors below, that shows
an example of module type captive screws and ejectors.
2.2.4.1 Install the DCM Module
1. Slide the DCM to its slot in the HEU chassis (Refer to 2.6.2 for module slot positioning).
2. Secure the DCM to the Rack with the 2 captive screws
2.2.4.2 Install the rest of the Modules
(Refer to 2.6.2 for module slot positioning)
Referring to the following figure, secure the modules to the backplane by:
x Closing the ejectors (for relevant modules)
x Tightening the captive screws
Figure 5: Module Captive Screws and Ejectors
Captive
screws