User's Manual

User Manual v1.0
UM - Everon 6000 DAS - 1-MAR-2021 - clear of comments| March 2021 |Page 36 of 174
2.2.5 Connect the Cables
2.2.5.1 Ground
The grounding connection is performed via a two-hole, standard barrel grounding lug located on the HEU
rear panel.
• For use with stranded copper wire conductors
• 10-14 AWG
• Holes - 1/4 inch
Grounding Lug (Chassis Rear)
2.2.5.2 Connect RIMS to RF Source(S)
For each RIM - connect the external RF source to the corresponding RIM (service specific) Simplex or Duplex
QMA connectors:
a. For each RIM - connect the RF coax cable to the RIM’s Simplex or Duplex QMA connectors.
b. Route the connected cables through the Cable Management Tray towards the right or left
of the tray (depending on the module location in the chassis).
c. Connect the RF coax cable from the RIM to the corresponding external RF source.
RIMs connections
G
roundin
g
Lu
g
(
C
5
.
2
2
Co
n
nn
n
e
c
t
t
RI
RI
RI
MS
MS
MS
MS
to
to
toto
RF
RF
RF
S
ou
u
r
rc
rc
e
(
S)
S)
ch
RIM
-
c
onnect the external RF source to the
c
onnectors
: