User's Manual

User Manual v1.0

UM - Everon 6000 DAS - 1-MAR-2021 - clear of comments| March 2021 |Page 81 of 174

2.7.4 Wall Mount

This section provides instructions on how to assemble the wall-mount bracket onto the MRU and mount the

assembly on the wall (belly-to-wall installation).

Note: The installer is responsible for accommodating the installation to the surface type. The

mounting surface shall be capable of supporting the weight of the equipment. The weight of a

fully populated MRU chassis is 92.59 lbs (42 kg).

ATTENTION! In the event that a PAM or the OPTM needs to be removed from the chassis, make

sure to first press the release button on the module and then pull out using the handle (see Error!

Reference source not found.). Any attempt to pull out the module without first releasing may

cause damage.

Corning will not be liable for damage of products resulting from improper handling during

installation or repair.

Caution: Due to the chassis + 6 DPAMS weight, it is recommended the unit is carried by two

persons, to avoid damage to the system.

¾ To mount the MRU onto the wall

1. Select location and mark and drill appropriate holes in the wall

IMPORTANT! MRU is installed belly-to-the-wall with door opening rightward.

Note: Make sure that there is at least 16 inches of clearance to open the MRU door to the right

and to successfully remove and replace all modules.

Figure 12: Wall Mount Bracket