User's Manual

User Manual v1.0
UM - Everon 6000 DAS - 14-APR-2021 - clear of comments.docx| March 2021 |Page 124 of 202
5. Commissioning
This section describes all the initial configurations (commissioning) that must be done by the system
administrator, in order to perform commissioning and to add operators. Also – to configure maps:
 Create new user operators, see 5.1
 Set the system parameters (site, power sharing, time, TDD, adjustment), see 5.2
5.1 Create new user operators
Initially the system administrator is the only system user. To enable other users to log in to the system, the
system administrator must create user operators for the different providers/carriers.
When a new operator is created the administrator of the new operator must log in to add users to the
operator.
Only the system administrator can create new operators.
For more information about system security refer to section 6.1.3.2.
¾ To create a new operator
1. Log in as the system administrator.
2. In the main menu bar, click Æ
3. Click the Add operator button Æ enter the new operator name (alphanumeric characters only, no spaces)
and click OK. Up to 31 operators can be created.
4. The new operator name is added to the list of defined operators and the operator administrator is
automatically created with the following default authentication:
x Username: admin
x Password: admin
x Operator: operator name
Note: Default Passwords should be changed when the relevant users first log in to the
system. See password changing flow below. System admin can't change the operator
admin password.