User's Manual

User Manual v1.0
UM - Everon 6000 DAS - 14-APR-2021 - clear of comments.docx| March 2021 |Page 84 of 202
2.7.6 Connect Fiber SFP+
Note: use SFP+ from the approved list provided by Corning.
1. Remove the rubber stopper from the source port.
2. Push the SFP+ connector into the port, until it clicks (note that there is only one correct direction for
plugging-in).
3. Remove the white plug-protectors from the end of the SFP+ cable.
4. Plug the SFP+ cable into the D-MRU port until it clicks.
5. connect the other edge of the cable to the source unit
Figure 15 Remove rubber stopper from port and from SFP+ Pluggable Transceiver and insert the SFP+ Pluggable
Transceivers (hot-pluggable optical transceiver module) into the port.
SFP+ Pluggable
Transceivers
LC/UPC SM DX
Cable