User's Manual

User Manual v1.0
UM - Everon 6000 DAS - 14-APR-2021 - clear of comments.docx| March 2021 |Page 118 of 202
Note: make sure the values you enter in the above fields aren't used by other system elements,
and are different than the default values.
Make sure the address format matches IPv4 or IPv6, according to the tab being updated.
For Dynamic IP Address — set
DHCP
as
Client
, then click
OK
.
5. The HCM restarts after the LAN IP address is updated.
6. To open a remote management session: Open a browser and enter the
LAN port IP Address
in the
address
bar
.
Note: A Ping Tool option is provided to verify access to IP hosts (rather than opening another
application). For more information about the ping tool and the IP Settings tab refer to section
6.1.3.6.
4. Once the connection is established (can be verified by accessing through command prompt: cmdÆ
ipconfig -h) , open a browser and type-in the LOCAL port default IP address in the address bar:
172.16.1.1.
The HCM Controller Log In dialog appears:
5. For first-time authentication use the following default values:
x Username: admin
x Password: default provided with your system
x Group: leave blank
Note: IMPORTANT! For security reasons it is highly recommended to immediately change the
password (via the "Admin" -> "Security" tab) and log in again using the new password.
6. Click the "SIGN IN" button. System GUI main screen appears.
Type IP address is:
172.16.1.5. in browser