User's Manual

User Manual v1.0
UM - Everon 6000 DAS - 14-APR-2021 - clear of comments.docx| March 2021 |Page 175 of 202
7.1 SNMP Setup
This section details the following steps, required to set SNMP trap monitoring:
1. Through Everon GUI: Set the SNMP protocol version parameters (SNMPv2 / SNMPv3), see 7.1.1
2. Through Everon GUI: Set traps monitoring destination addresses, see 7.1.2
3. Through your 3rd party SNMP monitoring tool: Load the MIB files, see 7.1.3
7.1.1 Set Protocol Version Parameters (SNMPv2 / SNMPv3)
¾ To set SNMP version:
1. Choose Admin from the main menu Æ SNMP Config. The following screen appears:
2. In the following instructions, refer to the protocol version relevant in your deployment, and perform the set
of instructions listed below.