User's Manual

Corning Optical Communications
User Manual
|
Page 7
3. Installation Preparation
Unpacking and Inspecting
This section discusses the procedures for receiving the shipment, inspecting the packing container, unpacking, and
inspecting the device.
Inspecting the Packing Container
Handle the packing container carefully. Inspect the packing container immediately on arrival at the installation site to
verify that no apparent damage occurred during shipment. Ensure that the container is sound and that the waterproof
and vibration warning notices are still visible. If possible, always inspect the equipment in the presence of the delivery
person.
If any damage is observed:
1. Do not open or unpack the container.
2. Immediately contact the transportation carrier and notify them of the damage.
3. File a claim with the carrier once you determine the extent of any damage.
4. Return it to SUNWAVE’s nearest RMA facility and contact SUNWAVE for RMA processing.
Unpacking the Device
If the container appears to be in satisfactory condition:
1. Ensure both user and supplier representatives are in attendance during shipment inspection.
2. Confirm where you will store the device.
3. Ensure procedures are in place to handle the device and other equipment properly.
4. Ensure the following tools are available to unpack the shipment: hammer, paper cutter, and crowbar.
5. Open the packing container carefully. The device is contained in a protective package inside the packing container;
however, caution is still necessary so as not to damage the internal package and device.
6. Remove the internal package from the packing container.
7. Unpack the device from the internal package carefully.