Installation Manual

Installation Manual
|
CMA-794-AEN
|
Page 4
GENERAL
The Everon™ 6200 system components are designed for maximum safety and reliability when
they are installed, used, and maintained by trained and qualified technicians in accordance with
the procedures and instructions contained in this manual. To ensure the safe operation of your
system, always follow the safety and operational recommendations in this manual.
WARNINGS
Everon™ 6200 is not a consumer product. Please install and use Everon™ 6200 in accordance
with the instructions. Before installing or modifying any Everon™ 6200 equipment, read and fully
understand the entire instructions in this guide.
Only qualified personnel are authorized to install and maintain the Everon™ 6200 system.
Changes or modifications to the Everon™ 6200 equipment not expressly approved by the
manufacturer could void the product warranty and the user’s authority to operate the equipment.
Follow Electro Static Discharge precautions to avoid any damage to PCB, PSU, etc.
Keep equipment powered-off during installing or modifying.
Low path-loss cables connected to antennas are highly recommended.
SITE CONSIDERATIONS
Everon™ 6200 complies with FCC RF exposure limits for an uncontrolled environment.
The system delay should be taken into consideration when there are neighboring BTS sites with
overlapping coverage.
Pick an ideal easy-to-reach location for installation convenience.
Verify that there is a minimum of a 50 cm radius of space around Everon™ 6200 equipment for
the convenience of maintenance and on-site inspection.
In accordance with wireless service provider standards, it is not advised to use digital repeaters
as a signal source for Corning solutions.
Install Master A2 close to the service area for monitor and debugging.
ENVIRONMENTAL
Humidity and temperature have adverse efforts on the reliability of the Everon™ 6200 system.
Therefore, it is highly recommended to install the equipment in locations with stable humidity,
temperature, and ventilation.
The equipment has to operate within the following humidity level and temperature range:
Maximum humidity: 85%
Temperature range: -10°C to 40℃