User Manual

cr8D receiver instructions.txt

English

Receiver and Transmitter Setup Instructions

By following these steps you will ensure your transmitter and receiver are

properly setup and ready to fly.

1. Turn the transmitter on and adjust your transmitter to PPM mode and then

turn the transmitter off.

2. Press and hold the programming button on the transmitting module, then

turn the transmitter on. Please make sure the antenna has been attached to

the transmitter module before turning on the transmitter. The LED on Module

will flash between red and yellow indicating the transmitter is ready to

program.

3.On the back of the receiver is a button Press and hold the button on the

receiver. Connect the receiver to the battery. Plug the battery in so the

positive lead is toward the top or lettering. The number side of the

receiver is the positive side. The LED on the receiver will flash two

times, then it flashes for about 5 seconds, indicating the receiver and

transmitter are communicating on the same frequency. Turn off the

ransmitter and receiver.

4. Turn the transmitter on, the light on the transmitter module will turn

red. Connect the receiver to the battery. The LED on the receiver will

light red without any flash indicating the receiver is operating properly.

If the LED on the reciever flashes turn both units off and power both up

again untill the reciever light goes solid red.

After following these steps to program your transmitter and receiver both

modules will continue to operate on the same frequency each time you use

the modules. If there is a need to reprogram your modules (adding another

receiver) repeat steps 1 to 4. We hope you enjoy your new 2.4 Ghz receiver

and transmitter modules. They have been designed and produced using the

highest quality control measures available. If you have any questions

please do not hesitate to contact us or visit our website.

Type: CR8D

Size: 46.6x26x14.9mm(1.83"x1"x0.58")

Weight: 13.1g

Range: >1.5km/4900ft

Sensitivity: -100dbm

Number of Channel: 8

Operating voltage: 4.8V-6V

Operating current: 30mA

Transfer rate: 128kpbs

Resolution: 10bit

Compatible with: CT8F/CT8J /CT8Z/CT3F/CT14F(DSSS)

Latency: 22ms

PAGE 1
cr8D receiver instructions.txt English Receiver and Transmitter Setup Instructions By following these steps you will ensure your transmitter and receiver are properly setup and ready to fly. 1. Turn the transmitter on and adjust your transmitter to PPM mode and then turn the transmitter off. 2. Press and hold the programming button on the transmitting module, then turn the transmitter on. Please make sure the antenna has been attached to the transmitter module before turning on the transmitter.
PAGE 2
DEUTSCH Empfänger und Sender-Setup-Anleitung Durch die folgenden Schritte stellen Sie sicher dass ihr Sender und Empfänger korrekt eingerichtet und bereit zum Betrieb ist. 1. Schalten Sie den Sender ein und stellen Sie Ihren Sender auf PPM-Modus und schalten Sie dann den Sender aus. 2. Halten Sie die Programmiertaste am Sendemodul, dann schalten Sie den Sender ein. Bitte stellen Sie sicher, dass die Antenne auf das Sender-Modul angebracht worden ist vor dem Einschalten des Senders.