User Manual

CORONA 2.4GHz Spread Spectrum
(FASST COMPATIBLE)
Receiver Instruction Manual
(R8FA and R14FA)
Compatibility:
CORONA 2.4GHz Spread Spectrum FASST Compatible Receiver is designed to use with FUTABA FASST
2.4GHz transmitters, such as TM7, TM8, TM10, TM14 or T6EX-2.4G, 7C-2.4G, 8FG, 10CG, 12FG
Specifications:
Operating Current: 70mA @ FASST 7ch mode normal and 110 mA max,
80mA @ FASST multi-channel mode normal and 110 mA max
Operating Voltage: 4.0 ~ 10V
Latency: 7ms for high speed PPM (HS), l4ms for low speed PPM (LS) @ FASST multi-channel
mode (HS mode only available on the R8FA)
8ms for high speed PPM (HS), l6ms for low speed PPM (LS) @ FASST 7ch mode
(HS mode only available on the R8FA)
Sensitivity: about -96dbm
Setup:
Bind procedure:
 Turn on the FASST transmitter
 Connect the battery to the receiver while pressing receivers F/S button.
 The Dual-color LED’s continuous will cycle through the following:
o Red LED light (searching radio signal)
o Green LED light (acquired the radio signal)
o Red LED off (bind Ok)
o Green LED flashes 10 times (ID store in memory)
o Green LED lights solid (normally operation)
Fail-safe setting:
There are two ways to set the Failsafe setting on the CORONA 2.4GHz Spread Spectrum FASST Compatible
Receiver;
1. TX-failsafe feature: This method is to set failsafe on the FASST transmitter and has priority (works on channel
3 only under FASST 7ch mode or on multiple-channels under FASST multi-channel mode) while the receiver is
working on, just like the FUTABA receivers.