User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. RS232 SERIAL PROTOCOL PRESENTATION
- 3. setting the internal parameters of the wavecard
- 3.1- Configuration of the functional parameters
- 3.2- Configuration of the control parameters
- 3.2.1 - selection of the radio operating channel when FHSS is deselected
- 3.2.2 - Selection of the RF medium physical mode
- 3.2.3 - Selection of the radio board emission power
- 3.2.4 - Activation of the Wavenis RF Asic RSSI threshold autocorrection
- 3.2.5 - Selection of the serial baudrate.
- 3.2.6 - Reading the firmware version of the WaveCard
- 3.2.7 - Reading the RSSI level (Received Signal Strengh Indicator)
- 3.2.8 - TEST Mode
- 4. SERVICE COMMANDS
- 5. COMMUNICATION MODES
- 5.1- 'Frame Exchange’ Mode
- 5.2- 'Message’ Mode
- 5.3- ’Polling’ Mode
- 5.4- ’Broadcast’ mode
- 5.4.1 - Configuration of the parameters relating to the 'Broadcast' mode
- 5.4.2 - 'BroadCast' mode without waiting for a response
- 5.4.3 - 'BroadCast' mode with waiting for responses
- 5.4.4 - Format of the commands – from the request transmitter side
- 5.4.5 - Format of the commands – from the request receiver side
- 5.4.6 - Use of the selective, or not-selective broadcast mode
- 5.5- ’Multi frames' Mode
Document : WCAMODHEL.sxw
➢ Frame RECEPTION_ERROR format
With this command, the local WaveCard informs its host that a problem appeared at the time of the radio
exchange.
This command is forwarded only on the serial link, between the wavecard and its host, it thus does not
require an address of recipient.
Note: The error messages are activated only if parameter EXCHANGE_STATUS is positioned with
0x01, or 0x03.
In this last case, status messages are also activated, but does not intervene in this mode, only at
the time of the sending of a message without waiting of answer (MESSAGE, and BROADCAST
mode).
In Point-to-Point mode
RECEPTION_ERROR
HEADER CMD D ATA CRC ETX
3 bytes 1 byte 1 byte 1 byte 2 bytes 1 byte
0xFF ; 0x02 ;
0x06
0x31
EXCHANGE_MODE :
= 0x01 : Point-to-Point
mode
ERROR_TYPE :
= 0x01 : Distant equipment RF
acknowledge not received
(useful if acknowledge
mechanism is set)
= 0x02 : Distant equipment RF
response not received.
0x03
In Relaying mode
RECEPTION_ERROR
HEADER CM D D ATA CRC ETX
3 bytes 1 byte 1 byte 1 byte 1 byte 2 bytes 1 byte
0xFF ;
0x02 ;
0x06
0x31
EXCHANGE_MOD
E :
= 0x02 : relaying
mode
0x02
Default value
for relaying
mode
RELAY_COUNTER :
= 0x03 No response from the third
repeater;
= 0x02 No response from the second
repeater;
= 0x01 No response from the first
repeater;
= 0x00 No response from the final
equipment.
0x03
In both cases, the procedure of sending an error frame depends on parameter RADIO_ACKNOWLEDGE:
WCAMODHEL Handbook page 42 of 74