User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. RS232 SERIAL PROTOCOL PRESENTATION
- 3. setting the internal parameters of the wavecard
- 3.1- Configuration of the functional parameters
- 3.2- Configuration of the control parameters
- 3.2.1 - selection of the radio operating channel when FHSS is deselected
- 3.2.2 - Selection of the RF medium physical mode
- 3.2.3 - Selection of the radio board emission power
- 3.2.4 - Activation of the Wavenis RF Asic RSSI threshold autocorrection
- 3.2.5 - Selection of the serial baudrate.
- 3.2.6 - Reading the firmware version of the WaveCard
- 3.2.7 - Reading the RSSI level (Received Signal Strengh Indicator)
- 3.2.8 - TEST Mode
- 4. SERVICE COMMANDS
- 5. COMMUNICATION MODES
- 5.1- 'Frame Exchange’ Mode
- 5.2- 'Message’ Mode
- 5.3- ’Polling’ Mode
- 5.4- ’Broadcast’ mode
- 5.4.1 - Configuration of the parameters relating to the 'Broadcast' mode
- 5.4.2 - 'BroadCast' mode without waiting for a response
- 5.4.3 - 'BroadCast' mode with waiting for responses
- 5.4.4 - Format of the commands – from the request transmitter side
- 5.4.5 - Format of the commands – from the request receiver side
- 5.4.6 - Use of the selective, or not-selective broadcast mode
- 5.5- ’Multi frames' Mode
Document : WCAMODHEL.sxw
APPENDIX 2 : Electric interface of the WAVECARD
➢ WaveCard - 25mW
PIN # PIN NAME DESCRIPTION INPUT / OUTPUT
1 TX
TX RS232 signal OUTPUT
2 RX
RX RS232 signal INPUT
3 RE SET
RESET input (active to high level) INPUT
4 OUT2
Not used OUTPUT
5 OUT1
output active (level 1) when reception is on OUTPUT
6 GND
ground OUTPUT
7 +3V OUT
3V regulated output voltage (10mA available) OUTPUT
8
SUPP LY
VO LTAGE
input supply voltage (4V to 5.5V)
minimum current 45mA
INPUT
➢ WaveCard - 500mW
PIN # PIN NAME DESCRIPTION INPUT / OUTPUT
1 TX
TX RS232 signal (0 ;+2,7Vmax) OUTPUT
2 RX RX RS232 signal (0 ;+2,7Vmax) INPUT
3 RESET
RESET input (active to high level)
INPUT
4 OUT2
Not used
OUTPUT
5 OUT1
output active (high level) when periodic reception is on
OUTPUT
6 GND
ground
OUTPUT
7 +2,7V OUT
2,7V regulated output voltage (10mA available)
OUTPUT
8
SUPP LY
VO LTAGE
input supply voltage [3V à 4,3V]
• 700mA minimum current peak
INPUT
WCAMODHEL Handbook page 69 of 74