User's Manual

Document : WCAMODHEL.sxw
0x10
S WITCH_MODE_STATUS : automatic selection of
Radio physical mode used to address an equipment
depending on radio address
0 : automatic selection deactivated
1 : automatic selection activated
Default value, SWITCH_MODE_STATUS =
0x00
1
0x16
WAVECARD_MULTICAST_GROUP : Byte
containing the Multicast Group of the Wavecard
(available from V2.00 version ).
By default, no group selected = 0xFF 1
0x17
BCST_RECEPTION_TIMEOUT : timeout used for the
reception of CSMA frame consecutively to
REQ_SEND_BROADCAST Command emission
(available from firmware V2.01 version )
Valeur in multiples of100ms.
Default = 0x3C (6 seconds)
1
APPENDIX 4 : List of the commands of parameters setting
CMD Name Description
0x40 REQ_WRITE_RADIO_PARAM
Request to update the radio parameters
0x41 RES_WRITE_RADIO_PARAM
Response from the radio board to the radio parameters update
0x42 REQ_CHANGE_UART_BDRATE
Request to update serial link Baudrate
0x43 RES_CHANGE_UART_BAUDRATE
Response from the radio board to the serial link baudrate update. Serial Link
Baudrate is updated once the exchange is ended
0x44 REQ_CHANGE_TX_POWER
(1)
Request to update radio board emission power
0x45 RES_CHANGE_TX_POWER
(1)
Response from the radio board to the emission power update
0x46 REQ_WRITE_AUTOCORR_STATE
Request to update WAVENIS RF ASIC RSSI Threshold autocorrection
state
0x47 RES_WRITE_AUTOCORR_STATE
Response from the radio board to the WAVENIS RF ASIC
autocorrection state update
0x50 REQ_READ_RADIO_PARAM
Request to read the radio parameters.
0x51 RES_READ_RADIO_PARAM
Response from the radio board to a parameters reading.
0x54 REQ_READ_TX_POWER
Request to read radio board emission power
0x55 RES_READ_TX_POWER
Response from the radio board to the emission power reading
0x5A REQ_READ_AUTOCORR_STATE
Request to read WAVENIS RF ASIC RSSI Threshold autocorrection
state
0x5B RES_READ_AUTOCORR_STATE
Response from the radio board to the WAVENIS RF ASIC
autocorrection state reading.
0x60 REQ_SELECT_CHANNEL
Request to select the radio operating channel when FHSS is deselected
0x61 RES_SELECT_CHANNEL
Response to the channel selection request
0x62 REQ_READ_CHANNEL
Request to read the radio operating channel when FHSS is deselected
0x63 RES_READ_CHANNEL
Response to the read channel request
0x64 REQ_SELECT_PHYCONFIG
Request to select the RF medium physical mode
0x65 RES_SELECT_PHYCONFIG
Response to the physical mode selection request
0x66 REQ_READ_PHYCONFIG
Request to read the RF medium physical mode
0x67 RES_READ_PHYCONFIG
Response to the physical mode reading request
0x68 REQ_READ_REMOTE_RSSI
request to read RSSI level from remote equipment
0x69 RES_READ_REMOTE_RSSI
Response to the read remote RSSI level request
0x6A REQ_READ_LOCAL_RSSI
Request to read the Wavecard RSSI level on an exchange with a distant
equipment
0x6B RES_READ_LOCAL_RSSI
Response to the read local RSSI level request
WCAMODHEL Handbook page 71 of 74