User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. RS232 SERIAL PROTOCOL PRESENTATION
- 3. setting the internal parameters of the wavecard
- 3.1- Configuration of the functional parameters
- 3.2- Configuration of the control parameters
- 3.2.1 - selection of the radio operating channel when FHSS is deselected
- 3.2.2 - Selection of the RF medium physical mode
- 3.2.3 - Selection of the radio board emission power
- 3.2.4 - Activation of the Wavenis RF Asic RSSI threshold autocorrection
- 3.2.5 - Selection of the serial baudrate.
- 3.2.6 - Reading the firmware version of the WaveCard
- 3.2.7 - Reading the RSSI level (Received Signal Strengh Indicator)
- 3.2.8 - TEST Mode
- 4. SERVICE COMMANDS
- 5. COMMUNICATION MODES
- 5.1- 'Frame Exchange’ Mode
- 5.2- 'Message’ Mode
- 5.3- ’Polling’ Mode
- 5.4- ’Broadcast’ mode
- 5.4.1 - Configuration of the parameters relating to the 'Broadcast' mode
- 5.4.2 - 'BroadCast' mode without waiting for a response
- 5.4.3 - 'BroadCast' mode with waiting for responses
- 5.4.4 - Format of the commands – from the request transmitter side
- 5.4.5 - Format of the commands – from the request receiver side
- 5.4.6 - Use of the selective, or not-selective broadcast mode
- 5.5- ’Multi frames' Mode
Document : WCAMODHEL.sxw
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- reorient or relocate the receiving antenna.
- increase the separation between the equipment and receiver.
- connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– consult the dealer or an experienced radio/TV technician for help.
NOTE : The end product requires Professional installations. The installer/ integator who integrate yhe modul
must instruct third parties of their responsabilities with regards to professional Installation for compliance with
FCC requirements
The product that integrated the modul must to place the FCC of modul on the outside of product with the
following similar statement “ Contains FCCID : S28-WCAMODHEL”.
WCAMODHEL Handbook page 74 of 74