User's Manual

Document : CS-SUP-MUTI-WPORTAPP-E02.sxw
 With RELAY_ROUTE_STATUS parameter activated ( = 0x01 )
➢ Frame RECEPTION_ERROR format
With this command, the local WaveCard informs its host that a problem appeared at the time of the radio
exchange.
This command is forwarded only on the serial link, between the wavecard and its host, it thus does not
require an address of recipient.
Note: The error messages are activated only if parameter EXCHANGE_STATUS is positioned with
0x01, or 0x03.
 In 'Point-to-Point' mode
RECEPTION_ERROR
HEADER CMD DATA CRC ETX
3 bytes 1 byte 1 byte 1 byte 2 bytes 1 byte
0xFF ; 0x02 ; 0x06 0x31
EXCHANGE_MODE :
= 0x01 : Point-to-Point mode
ERROR_TYPE :
= 0x01 : Distant equipment RF acknowledge
not received (useful if acknowledge
mechanism is set)
= 0x02 : Distant equipment RF response not
received.
0x03
WaveCard user handbook page 47 of 67