User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. RS232 SERIAL PROTOCOL PRESENTATION
- 3. setting internal waveport CF parameters
- 3.1 Configuring functional parameters
- 3.2 Wake-up and synchronization
- 3.3 Configuring control parameters
- 3.3.1 Selecting RF communication mode
- 3.3.2 Selecting radio channel when FHSS is deselected
- 3.3.3 Selecting radio board transmission power
- 3.3.4 Activating RSSI threshold auto-correction
- 3.3.5 Selecting the serial baud rate
- 3.3.6 Reading Waveport CF firmware version
- 3.3.7 Reading RSSI
- 3.3.8 RSSI command format
- 3.3.9 TEST Mode
- 4. SERVICE COMMANDS
- 5. COMMUNICATION MODES
Waveport CF user manuel Coronis Systems
2.3.3 Service commands
Service commands are used to configure a Waveport CF or to read radio parameters independently of the
connected host equipment.
When a Waveport CF recognizes a service command, no data is sent to the connected host. These
commands are mainly used to handle:
• Detection of remote RF modules
• Link budgets with respect to remote modules (RSSI level detection)
• Setting parameters via RF
The details of the frame format and its usage are described in chapter 4.
Compact_Flash-UserManual 14