User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. RS232 SERIAL PROTOCOL PRESENTATION
- 3. setting internal waveport CF parameters
- 3.1 Configuring functional parameters
- 3.2 Wake-up and synchronization
- 3.3 Configuring control parameters
- 3.3.1 Selecting RF communication mode
- 3.3.2 Selecting radio channel when FHSS is deselected
- 3.3.3 Selecting radio board transmission power
- 3.3.4 Activating RSSI threshold auto-correction
- 3.3.5 Selecting the serial baud rate
- 3.3.6 Reading Waveport CF firmware version
- 3.3.7 Reading RSSI
- 3.3.8 RSSI command format
- 3.3.9 TEST Mode
- 4. SERVICE COMMANDS
- 5. COMMUNICATION MODES
Waveport CF user manuel Coronis Systems
The periodic wake-up having to occur when waiting of synchronization, are
memorized (in order to preserve the periodicity), but not carried out.
At the end of the the wake-up phase, the transmitter modules sends a synchronization sequence, followed by
the data to be transmitted.
3.2.2 Examples of different wake-up conditions
Typical case (Long WakeUp = receiver WakeUp period + 100 ms):
Case where wake-up is too short (lower than the receiver's WakeUp period):
Compact_Flash-UserManual 20