User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. RS232 SERIAL PROTOCOL PRESENTATION
- 3. setting internal waveport CF parameters
- 3.1 Configuring functional parameters
- 3.2 Wake-up and synchronization
- 3.3 Configuring control parameters
- 3.3.1 Selecting RF communication mode
- 3.3.2 Selecting radio channel when FHSS is deselected
- 3.3.3 Selecting radio board transmission power
- 3.3.4 Activating RSSI threshold auto-correction
- 3.3.5 Selecting the serial baud rate
- 3.3.6 Reading Waveport CF firmware version
- 3.3.7 Reading RSSI
- 3.3.8 RSSI command format
- 3.3.9 TEST Mode
- 4. SERVICE COMMANDS
- 5. COMMUNICATION MODES
Waveport CF user manuel Coronis Systems
Exchange with radio acknowledgement
Example of parameter configuration for wake-up management
In this example, the transmitter sends data to the receiver quickly between two relatively long
idle periods:
1) Send a parameter modification command to the receiver to modify its WakeUp period to
0 (nearly constant reception).
2) Set the transmitter's WakeUp_Length parameter to 40 ms.
3) Send the data to the receiver.
4) Send a parameter modification command to the receiver to set its wake-up period to 10 s
(default value).
5) Set the transmitter's WakeUp_Length parameter to 1100 ms (default value).
3.3 Configuring control parameters
Control parameters are used to:
• Modify RF and serial communications
• Retrieve information about the local module and communication quality with a remote module
Compact_Flash-UserManual 22