User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. RS232 SERIAL PROTOCOL PRESENTATION
- 3. setting internal waveport CF parameters
- 3.1 Configuring functional parameters
- 3.2 Wake-up and synchronization
- 3.3 Configuring control parameters
- 3.3.1 Selecting RF communication mode
- 3.3.2 Selecting radio channel when FHSS is deselected
- 3.3.3 Selecting radio board transmission power
- 3.3.4 Activating RSSI threshold auto-correction
- 3.3.5 Selecting the serial baud rate
- 3.3.6 Reading Waveport CF firmware version
- 3.3.7 Reading RSSI
- 3.3.8 RSSI command format
- 3.3.9 TEST Mode
- 4. SERVICE COMMANDS
- 5. COMMUNICATION MODES
Waveport CF user manuel Coronis Systems
3.3.2 Selecting radio channel when FHSS is deselected
You may select the Waveport CF radio channel using these commands:
CMD Name Description
0x60 REQ_SELECT_CHANNEL
Request to select operating radio channel when FHSS is
deselected
0x61 RES_SELECT_CHANNEL Response to channel selection request
0x62 REQ_READ_CHANNEL
Request to read the operating radio channel when FHSS is
deselected
0x63 RES_READ_CHANNEL Response to the read channel request
These commands are used only when the radio communication mode is mono-
frequency with channel selection.
Format of read commands for channel used
• Request (host to Waveport CF)
REQ_READ_CHANNEL
HEADER CMD CRC ETX
3 bytes 1 byte 2 bytes 1 byte
0xFF ; 0x02 ; 0x04 0x62 0x03
• Response ( Waveport CF to host)
RES_READ_CHANNEL
HEADER CMD DATA CRC ETX
3 bytes 1 byte variable 2 bytes 1 byte
0xFF ; 0x02 ; 0xXX 0x63
Status = 0x00
read OK
Channel number
1 byte
Status = 0x01
Read error
-
0x03
Compact_Flash-UserManual 25