User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. RS232 SERIAL PROTOCOL PRESENTATION
- 3. setting internal waveport CF parameters
- 3.1 Configuring functional parameters
- 3.2 Wake-up and synchronization
- 3.3 Configuring control parameters
- 3.3.1 Selecting RF communication mode
- 3.3.2 Selecting radio channel when FHSS is deselected
- 3.3.3 Selecting radio board transmission power
- 3.3.4 Activating RSSI threshold auto-correction
- 3.3.5 Selecting the serial baud rate
- 3.3.6 Reading Waveport CF firmware version
- 3.3.7 Reading RSSI
- 3.3.8 RSSI command format
- 3.3.9 TEST Mode
- 4. SERVICE COMMANDS
- 5. COMMUNICATION MODES
Waveport CF user manuel Coronis Systems
Revision History
Rev. Description Author Date Comments
1 Original document KRI Sept 2009
Supported firmware
Card Compatible Firmware
Waveport CF 2.01 and higher
FCC APPROVAL
This module complies with part 15 of the FCC rules. Operation is subject to the
following two conditions: this module may not cause harmful interference, and this
module must accept any interference received, including interference that may
cause undesired operation.
Caution: any changes or modifications not explicitly approved by Coronis-Systems
could void the user's authority to operate the equipment.
Compact_Flash-UserManual 3