User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. RS232 SERIAL PROTOCOL PRESENTATION
- 3. setting internal waveport CF parameters
- 3.1 Configuring functional parameters
- 3.2 Wake-up and synchronization
- 3.3 Configuring control parameters
- 3.3.1 Selecting RF communication mode
- 3.3.2 Selecting radio channel when FHSS is deselected
- 3.3.3 Selecting radio board transmission power
- 3.3.4 Activating RSSI threshold auto-correction
- 3.3.5 Selecting the serial baud rate
- 3.3.6 Reading Waveport CF firmware version
- 3.3.7 Reading RSSI
- 3.3.8 RSSI command format
- 3.3.9 TEST Mode
- 4. SERVICE COMMANDS
- 5. COMMUNICATION MODES
Waveport CF user manuel Coronis Systems
Here is the format of these frame types:
• Response received by host (RELAY_ROUTE_STATUS deactivated)
RECEIVED_FRAME
HEADER CMD DATA CRC ETX
3 bytes 1 byte 6 bytes variable 2 bytes 1 byte
0xFF ;
0x02 ;
0xXX
0x30
Radio address of
transmitting module
Data from received frame
Maximum size (N bytes) is defined below
0x03
• Response received by host (RELAY_ROUTE_STATUS activated)
RECEIVED_FRAME_RELAYED
HEADER CMD DATA CRC ETX
3 bytes 1 byte 6 bytes 1 byte variable variable 2 bytes 1 byte
0xFF ; 0x02 ;
0xXX
0x35
Radio
address of
transmitting
module
Number of
repeaters
used
Radio
addresses of
repeaters
Data from received
frame
Maximum size (N bytes)
is defined below
0x03
The field containing the radio addresses of the repeaters can be 6, 12, or 18 bytes, depending on the number
of repeaters used.
Defining maximum size
• Point to Point mode Max = 152 bytes of data
• Relay mode Max = 152 – (2 + 6 x Number of repeaters)
=> 1 repeater: 144 bytes of data
=> 2 repeaters: 138 bytes of data
=> 3 repeaters: 132 bytes of data
Compact_Flash-UserManual 47