User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. RS232 SERIAL PROTOCOL PRESENTATION
- 3. setting internal waveport CF parameters
- 3.1 Configuring functional parameters
- 3.2 Wake-up and synchronization
- 3.3 Configuring control parameters
- 3.3.1 Selecting RF communication mode
- 3.3.2 Selecting radio channel when FHSS is deselected
- 3.3.3 Selecting radio board transmission power
- 3.3.4 Activating RSSI threshold auto-correction
- 3.3.5 Selecting the serial baud rate
- 3.3.6 Reading Waveport CF firmware version
- 3.3.7 Reading RSSI
- 3.3.8 RSSI command format
- 3.3.9 TEST Mode
- 4. SERVICE COMMANDS
- 5. COMMUNICATION MODES
Waveport CF user manuel Coronis Systems
5.1.3 Using relay mode.........................................................................................................................39
5.1.4 Managing time-outs......................................................................................................................41
5.2 Message mode.........................................................................................................................................44
5.2.1 Configuring message mode parameters......................................................................................44
5.2.2 Commands and formats..............................................................................................................44
5.2.3 Using relay mode.........................................................................................................................46
5.3 Polling mode.............................................................................................................................................50
5.3.1 Configuring polling mode parameters..........................................................................................50
5.3.2 Commands and formats...............................................................................................................51
5.3.3 Selective vs. non-selective polling mode......................................................................................52
5.3.4 Diagram of a polling mode exchange...........................................................................................55
5.4 Broadcast mode........................................................................................................................................57
5.4.1 Configuring broadcast mode parameters.....................................................................................57
5.4.2 Using broadcast mode (without waiting for response)..................................................................58
5.4.3 Using broadcast mode (waiting for responses)............................................................................59
5.4.4 Command format from the transmitter side..................................................................................61
5.4.5 Command format from the receiver side......................................................................................62
5.4.6 Using selective and non-selective broadcast modes....................................................................63
5.5 Multi-frame mode......................................................................................................................................64
5.5.1 Overview......................................................................................................................................64
5.5.2 Received frame format.................................................................................................................64
Appendix I – Waveport CF physical layout.................................................................................................65
Appendix II – Waveport CF electronic interface.........................................................................................67
Appendix III – Parameter list........................................................................................................................68
Appendix IV – Parameter setting commands.............................................................................................69
Appendix V – Data transmission commands..............................................................................................70
Compact_Flash-UserManual 5