User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. RS232 SERIAL PROTOCOL PRESENTATION
- 3. setting internal waveport CF parameters
- 3.1 Configuring functional parameters
- 3.2 Wake-up and synchronization
- 3.3 Configuring control parameters
- 3.3.1 Selecting RF communication mode
- 3.3.2 Selecting radio channel when FHSS is deselected
- 3.3.3 Selecting radio board transmission power
- 3.3.4 Activating RSSI threshold auto-correction
- 3.3.5 Selecting the serial baud rate
- 3.3.6 Reading Waveport CF firmware version
- 3.3.7 Reading RSSI
- 3.3.8 RSSI command format
- 3.3.9 TEST Mode
- 4. SERVICE COMMANDS
- 5. COMMUNICATION MODES
Waveport CF user manuel Coronis Systems
1. INTRODUCTION
Waveport Compact Flash allows you to establish Wavenis wireless links between modules in wireless mesh
networks, typically for machine-to-machine data communications, access control, security, and track 'n trace
applications. The module is driven through a USART link (RS232 or TTL) by an embedded client application
running on a connected host module, or by an application running on a PC (via installed Wavenis drivers).
Coronis Systems Waveport CF and Waveport products use the same Wavenis
wireless protocole. Therefore, this document covers both products, as well as
Waveport module with serial, USB, or compact flash connectors. We will
generally refer to Waveport CF, except where there are specific differences
between products
Waveport CF role is to:
• Send data frames wirelessly between host modules
• Notify the host module about received frames
Each Waveport CF needs to be connected to a host module in order to exchange data. However, Waveport
CF can process some specific frames without being connected to a host. These exchanges are called
Service Exchanges, and are mainly used for installation and maintenance procedures.
Compact_Flash-UserManual 6
Figure 1 : Waveport CF