User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. RS232 SERIAL PROTOCOL PRESENTATION
- 3. setting internal waveport CF parameters
- 3.1 Configuring functional parameters
- 3.2 Wake-up and synchronization
- 3.3 Configuring control parameters
- 3.3.1 Selecting RF communication mode
- 3.3.2 Selecting radio channel when FHSS is deselected
- 3.3.3 Selecting radio board transmission power
- 3.3.4 Activating RSSI threshold auto-correction
- 3.3.5 Selecting the serial baud rate
- 3.3.6 Reading Waveport CF firmware version
- 3.3.7 Reading RSSI
- 3.3.8 RSSI command format
- 3.3.9 TEST Mode
- 4. SERVICE COMMANDS
- 5. COMMUNICATION MODES
Waveport CF user manuel Coronis Systems
have to make sure that remote modules have their GROUP_NUMBER parameter configured.
Simply issue a broadcast request (with or without waiting for responses) with “group number” configured to
adjust selection.
• Group number = 0xFF 0xXX 0xXX 0xXX 0xXX 0xXX non-selective mode
• Group number = 0x01 0xXX 0xXX 0xXX 0xXX 0xXX selective mode
In the second case (selective mode), all Wavenis modules within radio range whose group number is set to
0x01 will receive the broadcast command.
Compact_Flash-UserManual 63