User's Manual

Waveport CF user manuel Coronis Systems
Appendix IV – Data transmission commands
CMD NAME DESCRIPTION
0x20 REQ_SEND_FRAME Request to send a radio frame and to wait for the radio response.
0x21 RES_SEND_FRAME
Radio board response to the frame transmission (response to 0x20,
0x22,0x24, 0x26, 0x28, 0x2A request)
0x22 REQ_SEND_MESSAGE Request to send a radio frame without waiting for radio response.
0x24
REQ_SEND_BROADCAST_RESPON
SE
Request to send a radio frame in response to a broadcast frame
0x26 REQ_SEND_POLLING Request to send a radio frame in polling mode.
0x28 REQ_SEND_BROADCAST Request to send a radio frame in broadcast mode.
0x2A
REQ_SEND_BROADCAST_MESSA
GE
Request to send a radio frame in broadcast mode without waiting for radio
response.
0x30 RECEIVED_FRAME Radio frame received by the radio board.
0x31 RECEPTION_ERROR
Frame indicating error type detected following last exchange in point-to-point
or relay mode.
0x32 RECEIVED_FRAME_POLLING Received radio frame following a REQ_SEND_POLLING request
0x34
RECEIVED_BROADCAST_RESPON
SE
Received radio frame following a REQ_SEND_BROADCAST request
0x35 RECEIVED_FRAME_RELAYED
Received radio frame relayed by the radio board. Reception of this command
is possible only if the RELAY_ROUTE_STATUS(0x06) parameter is set.
0x36 RECEIVED_MULTIFRAME
Received radio frame in multi-frame mode. Indicates that subsequent frames
are pending.
0x37 END_MESSAGE_EXCHANGE
Frame indicating end of message exchange. This frame is returned only after
0x22 & 0x24 & 0x2A request commands. Reception of this frame depends on
the value of EXCHANGE_STATUS.
0x38 RECEIVED_BROADCAST_FRAME Received a radio frame transmitted in broadcast mode
Compact_Flash-UserManual 68