User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. RS232 SERIAL PROTOCOL PRESENTATION
- 3. setting internal waveport CF parameters
- 3.1 Configuring functional parameters
- 3.2 Wake-up and synchronization
- 3.3 Configuring control parameters
- 3.3.1 Selecting RF communication mode
- 3.3.2 Selecting radio channel when FHSS is deselected
- 3.3.3 Selecting radio board transmission power
- 3.3.4 Activating RSSI threshold auto-correction
- 3.3.5 Selecting the serial baud rate
- 3.3.6 Reading Waveport CF firmware version
- 3.3.7 Reading RSSI
- 3.3.8 RSSI command format
- 3.3.9 TEST Mode
- 4. SERVICE COMMANDS
- 5. COMMUNICATION MODES
Waveport CF user manuel Coronis Systems
1.1 Scope of this document
The purpose of this document is to present:
• A low-level description of the exchange protocol used to drive the Waveport CF wireless board
through an asynchronous serial RS232 (±12V) or TTL level (0-3V) interface
• The Waveport CF electrical interface
• The Waveport CF mechanical interface
1.1.1 Terms
This document provides specifications for using supplied Wavenis DLLs for Windows as well as for writing
your own. This allows you to use Waveport CF as a wireless modem that can be integrated into existing
modules or driven by a specific host module with its own micro-controller.
As mentioned above, this document is valid for both Waveport CF and Waveport products. The main
difference is that Waveport is a ready-to-use Wavenis network interface for PCs with USB, serial, or compact
flash (type II) connectors.
In this documentation, host refers to the module or subsystem that drives the Waveport CF; radio board
indicates Waveport CF equipment.
1.1.2 Usage scenarios
Use Waveport CF to establish Wavenis connections from your PDA.
It's the same communication as Waveport (USB or RS232) with computer
Compact_Flash-UserManual 7