User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. RS232 SERIAL PROTOCOL PRESENTATION
- 3. setting internal waveport CF parameters
- 3.1 Configuring functional parameters
- 3.2 Wake-up and synchronization
- 3.3 Configuring control parameters
- 3.3.1 Selecting RF communication mode
- 3.3.2 Selecting radio channel when FHSS is deselected
- 3.3.3 Selecting radio board transmission power
- 3.3.4 Activating RSSI threshold auto-correction
- 3.3.5 Selecting the serial baud rate
- 3.3.6 Reading Waveport CF firmware version
- 3.3.7 Reading RSSI
- 3.3.8 RSSI command format
- 3.3.9 TEST Mode
- 4. SERVICE COMMANDS
- 5. COMMUNICATION MODES
Waveport CF user manuel Coronis Systems
2.1.2 Request / response mechanism
Some exchanges require using a request/response mechanism. In this case, a high-level acknowledgement
(command prefix: RES) is initiated by the RF board following the request frame (command prefix: REQ) sent
by the host.
Request frames are identified by “REQ_XXX_XXX” (i.e.
REQ_SEND_FRAME)
High-level acknowledgement frames are identified by “RES_XXX_XXX”
(i.e. RES_SEND_FRAME).
In this example, the RECEIVED_FRAME frame is the response to the REQ_SEND_FRAME request. High-
level acknowledgement of the request is identified by the RES_SEND_FRAME frame.
Compact_Flash-UserManual 9