Full Product Manual

Safety Data Sheet
5. Fire Fighting Measures
Extinguishing Media: Foam, carbon dioxide (CO2), water spray
Hazardous Combustion Products: Carbon monoxide, carbon dioxide, ketones, acrolein,
formaldehyde, aldehydes, oxides of nitrogen, unidentified organic compounds and other possible toxic
combustion products.
Explosion Hazard: Avoid generating dust; fine dust dispersed in air in sufficient concentrations, and in the
presence of an ignition source is a potential dust explosion hazard.
Special protective equipment for firefighters: Use self-contained breathing apparatus and full
protective gear.
Sensitive to Static Discharge: Static discharge could be an ignition source for a combustible
concentration of dust.
Sensitivity to Impact: Not Applicable
1. Accidental Release Measures
As supplied, the product presents no risk of spill or release.
GENERAL PROCEDURES: Dust deposits should not be allowed to accumulate on surfaces, as these may
form an explosive mixture if they are released into the atmosphere in sufficient concentration. Avoid
dispersal of dust in the air (i.e., clearing dust surfaces with compressed air).
2. Handling and Storage
GENERAL PROCEDURES: Keep away from heat, sparks and flame. Minimize dust generation and
accumulation. Routine housekeeping should be instituted to ensure that dusts do not accumulate on
surfaces. Avoid dispersal of dust in the air (i.e., clearing dust surfaces with compressed air).
HANDLING: If the product is cut or sanded, avoid exposure to dust and debris. Provide appropriate local
ventilation at machinery and at places where dust can be generated. In addition, wear suitable
respiratory equipment to avoid breathing dusts containing titanium dioxide and/or carbon black.
STORAGE: No special storage conditions are required. If multiple pallets of product are stacked, take
appropriate measures to avoid leaning or tipping of pallets. This product may react with strong
oxidizing agents and should not be stored near such materials. Store material in areas protected with
automatic sprinklers.
STORAGE TEMPERATURE: 60°C (140°F) Maximum
3. Exposure Controls and Personal Protection
ENGINEERING CONTROLS: Provide adequate room ventilation. Provide adequate ventilation in areas
where vapors can be generated. Eliminate ignition sources in areas where dust where dust could be
generated (e.g. cutting area). Ensure that dust-handling systems (such as exhaust ducts, dust collectors,
vessels, and processing equipment) are designed in a manner to prevent the escape of dust into the work
area (i.e., there is no leakage from the equipment). It is recommended that all dust control equipment such
Page 3 of 6
Distributed by Polymershapes | [e-mail] | 844.650.7700