User's Manual

Model: OMNI
C.P.S.C.16 CFR Part 1203
United States Federal Safety Standard for Bicycle Helmets
(Consumer Product Safety Commission)
CE, EN1078 (Europe Safety Standard)
FCC ID: YNGHA002-0001
FCC Part 15B,Part 15C
CE R&TTE Directive 1999/5/EC
AS/NZS 2063:2008 (Australia/New Zealand Bicycle Helmet
Safety Standard)
Safety Certifications
This manual covers important information with respect to
safety, operation and maintenance of the helmet, please read it
carefully before initial use.
1. No helmet can protect its user from all unforeseeable
accidents, including those involving bicycle-to-motor vehicle
collisions. The COROS™ helmet is designed to protect the head
and cannot guard against cervical, spine or other body injuries
that may result from an accident.
2. The helmet is designed to be retained by a strap under the
lower jaw. It is not intended for motorsport, moped or other
uses.
3. To be effective, the helmet must fit properly and be worn
correctly. Securely fasten retention system as shown on page
3-5. Grasp the helmet and try to rotate it to front and rear. A
correctly fitted helmet should be comfortable and should not
move forward to obscure vision or rearward to expose the
forehead.
4. No attachments should be made to the helmet except those
recommended by the helmet manufacturer.
5. The helmet is designed to absorb shock by partial
destruction of the shell and liner. This damage may not be
visible. Therefore, if subjected to a severe blow, the helmet
should be returned to coros under the impact replacement
program. visit www.coros.com for more information.
General Safety, Use and Care
PAGE 15 PAGE 16
authorized to assume liability on behalf of COROS™ in
connection with the sale or use of this product. This warranty
program covers all parts of your COROS™ product and applies to
all types of defects or failure, except for loss. If your COROS™
helmet is found to be defective in materials or workmanship
within one year(US & CA & AU)/two years(EU) from the date of
purchase, COROS™ or the country distributor will at its sole
option either repair or replace the helmet free of charge.
6. The helmet may be damaged and rendered ineffective by
petroleum and petroleum products, cleaning agents, paints,
adhesives, etc., without the damage being visible to the user.
7. A helmet has a limited lifespan and should be replaced when it
shows obvious signs of wear.
8. This helmet should not be used by children while climbing or
doing other activities where there is a risk of hanging or
strangulation should the child become trapped Please keep the
helmet out of reach from children under fi ve.
9. Please exercise care and good judgment whenever you ride.
Comply with all traffic laws and regulations and do your part to
avoid accidents of any kind.
10. Do not modify or remove any original components of your
helmet, other than as recommended by COROS™. Doing so will
void all COROS™ warranties.
11. Keep your helmet charged with the USB charging adapter.
12. Please mount the Smart Remote into the holder before
each use.
13. The product can be upgraded online through the COROS™
Application. Do not terminate power or force the helmet to turn
off in the course of upgrading; this could lead to booting failures.
14. The COROS™ helmet is water resistant.