User's Manual

LX220N User Manual
74
Click Add below the table DS-Lite IPv4 over IPv6 Tunnel List to add a DS-Lite
item, which is a 4in6 tunnel. The page shown in the following figure appears.
The following table describes the parameters of this page.
Field Description
Mechanism The tunnel type is DS-Lite, which is 4in6 tunnel.
Dynamic Set the obtaining mode of remote IPv6 addresses.
You can select 0 or 1.
RemoteIPv6Address Set the remote end IPv6 address of the tunnel.
Click Apply to enable the settings.
5.2.14.2 6in4 Tunnel
Choose Advanced > IP Tunnel and then click 6in4 Tunnel. The page shown in
the following figure appears. In this page, you can configure IPv6 penetration
through IPv4 network. When only IPv4 access is provided by your ISP, you can
access the Internet via IPv4 and IPv6.