User's Manual

LX220N User Manual
76
Click Apply to enable the settings.
Click Add below the table IPv6 Rapid Deployment to add a 6RD item, which is a
6in4 tunnel. The page shown in the following figure appears.
The following table describes the parameters of this page.
Field Description
Mechanism The tunnel type is 6RD, which is a 6in4 tunnel.
Dynamic Set the obtaining mode of Border Relay Address.
IPv4MaskLen Set the subnet mask digits of the IPv4 address of the
local WAN interface.
Prefix Set the IPv6 prefix of the 6RD tunnel.
BorderRelayAddress Set the Border Relay IPv4 address at the remote end.
Click Apply to enable the settings.
5.2.15
Logout
Choose Advanced > Logout. The page shown in the following figure appears. In
this page, you can log out of the configuration page.