Owner`s manual

4-9
Controls and Indicators
Navigation Lights
The “NAV/ANCHOR” switch controls the navigation lights. The
law requires the bow light and the 360 degree light (located near
the stern) be turned on while running the boat after sunset or
before dawn. NAV position will turn on the red and green
navigation bow lights, 360 degree white stern light and gauge
illumination.
Anchor Light
The “NAV/ANCHOR” switch turns on the 360 degree light. Insert
this light pole into the receptacle located near the stern and push
the anchor switch on the pod to turn this light on. This light is
required by law to be on after sunset and before dawn when the
boat is not moving.
Bilge Pump
The “BILGE” switch turns on the bilge pump to remove excess
water from the bottom of the boat. The 200 has a bilge pump in
front of the engine and an additional bilge pump at the back of the
boat. When you turn the switch on, the pump(s) will operate and
run for several moments to “sense” if there is water in the bilge. If
there is water in the bilge, the pump(s) remains on until the water
is pumped out. If there is no water in the bilge, the pump(s) will
turn off. If you want immediate pump action, turn the switch off
and then back on again. The pump(s) will turn on periodically to
determine if there is water in the bilge. If so, they will remain on
until the water is pumped out.
Blocking navigation lights can cause
death or serious injury. DO NOT block the navigation
lights.
!
D-Drive Sec 4_2013_Nautique Ski Sec 4.qxd 7/3/12 10:15 AM Page 9