Owner`s manual

4-20
Section 4
To lock the system, re-enter any of the three codes and press STOP.
Erasing the User Codes
Make sure the system indicator light is OFF.
Enter the Master Embedded Code, then press and release the 1/2
key and the 7/8 key at the same time to erase the system user codes.
The keyless ignition will now act as if there are no codes in memory.
Pressing the START key will unlock the system and pressing the
STOP key will lock it without entering a code. Follow the steps in
“Programming The Primary User Code” in this section.
Switches
Navigation/Anchor Lights
A quick press and release of this button turns on the navigation
lights, and the indicator light for this button will illuminate. A press
and slight hold will only turn on the anchor light and cause the
indicator light to flash. A press and release of the key turns off both
of the lights.
Bilge Pump
The bilge pump turns on or off by pressing and releasing the
button. The indicator light for this key will illuminate when the
pump is on.
D-Drive Sec 4_2013_Nautique Ski Sec 4.qxd 7/3/12 10:15 AM Page 20