Owner`s manual

4-24
Several alarm conditions may also be displayed in the LCD display
when needed:
1. Low fuel
2. Low oil pressure
3. High engine temperature
4. Low voltage
5. Engine RPM reduction due to engine controller command
6. RPM limit
7. Knock sensing system malfunction
8. Ignition system malfunction
9. Manifold pressure sensor (MAP) malfunction
10. Manifold temperature sensor malfunction
11. Throttle position sensor (TPS)
12. Cooler sensor malfunction
Alarm messages will be displayed on the tachometer LCD. Messages
1 through 5 will also include a flashing red light. All messages will
be displayed until either the problem is corrected and the trouble
code reset by your Correct Craft Dealer or the operator manually
cancels the warning message.
Canceling System Alarms
To manually cancel system warning messages, simultaneously press
both  and  on the tachometer.
This will disable the warning message temporarily. If the problem is
not corrected in one minute (five minutes for low fuel), the
warning will be displayed again. The operator can cancel as often
as needed.
Section 4
Correct Craft, Inc.
Nautique Sport Sec 4.qxd 7/28/03 12:45 PM Page 24