Specifications

the key is pushed and will stop when the key is released.
Dash Pod Switches
All dash pod switches interface with a sealed circuit breaker box located under
the bow. The circuit breaker box consists of sixteen soft opaque flexible vinyl
tubular shields which cover sixteen circuit switches. When the circuits are
functioning, the tubular shield is somewhat flexible. A tripped circuit breaker
will extend and fill the tubular shield, causing it to be inflexible. To locate a
tripped circuit breaker, run your fingers over the two rows of switches and
locate the switch shield that has become inflexible. To re-set, simply press in
the extended circuit switch shield.
Bilge pumps
The bilge pump switch turns on the bilge pumps.
There is a bilge pump down by the front of the
fuel tank and another bilge pump back by the
rudder. When you push the bilge pump key on the
keypad, both pumps will come on and run for
several moments to “sense” if there is water in the
bilge. If there is water in the bilge, they will
remain on until the water is pumped out. If there
is no water in the bilge, they will turn off. If you
want immediate pump action, turn the switch off
and then back on again. The pumps will turn on
periodically to determine if there is water in the
bilge. If so, they will remain on until the water is pumped out. Trash in bilge
can hurt bilge pump and fill pumps for ballast systems.
The “Bilge” switch must be turned on for this feature to operate. This will
not drain significant power from the battery unless the bilge pumps are
required to run frequently because of a leak or excessive rainwater. This
pumping system should not be relied on over an extended period of time.
We suggest you frequently inspect your boat.
1.61.6
Bilge Pump
Function Keys
Super Sport 210 2003.qxd 7/29/02 11:29 AM Page 1.6