Specifications

offers a unique fill and empty system.
By opening the flow rite valves located
underneath the dash to your left knee
and then pressing the port and starboard
ballast button on the keypad on the right
side of the dash, the tanks will fill. With
a three tank system, use the belly tank
ballast button. When the tanks are full,
press the buttons again and the pump will
turn off. Then close the valves. To empty, reverse this process by opening
the valves and press and momentarily hold the port and starboard ballast
buttons causing a blinking light to appear. Monitor your ballast tank gauge
located on the console to determine when the tanks are empty. Then turn off
pump and close valves. Should your boat have the belly tank, it is important
to always fill the belly tank if your port and starboard rear tanks are filled.
Winterization of Optional Launch Control System
In order to winterize the Launch Control System, take the following steps:
1. Make sure the launch control system seacocks (located in the bilge) are
open. Empty the system completely using the drain pumps.
2. On boats that do not have the storage locker tank, open the rear storage
compartments, remove the two drain hoses from their through-hull fittings,
remove the two vent hoses from their through-hull fittings, unplug the drain
pump, and remove each tank from the boat. Turn the tanks upside down and
allow all the water present to drain out the vent hoses. Be sure all the water
has drained from the pumps and hoses still in the boat.
If the boat is equipped with a storage locker tank, open the locker lid and
remove the drain plug from the back side of the tank. Allow the tank to drain
completely raising and lowering the bow of the boat to insure complete
drainage. Replace the drain plug.
3. Reinstall each tank by reversing the above procedure.
Optional Correct Craft Cruise Operating Instructions
Turn system ON (light blinks slowly, indicating system is armed)
Drive to desired speed, prese ENGAGE and the system takes control of the
throttle (Light stays on steady)
Pull back on the throttle and the system disengages. (Light blinks rapidly,
indicating RESUME function is ready)
Accelerate again and the system resumes control automatically at the last
speed used.
RESUME key feature will recall the last speed used even if the system was
1.17
Launch Control Seacocks
Super Sport 210 2003.qxd 7/29/02 11:30 AM Page 1.17