Installation & Assembly

Step 2
Step 3
Place the Chair on a LEVEL SURFACE to see if it wobbles.
If it wobbles, lift the Chair some 30cm to 50cm high from the ground.
Keep your feet and toes well away from the drop zone.
Drop the Chair freely and vertically with the four legs, hitting the ground, at
the same time.
This Drop Test will help to ensure that all the Bolts and gaps reach full
alignment status.
Test again for evenness on a LEVEL SURFACE.
If no wobbles are found, proceed to tighten all the Bolts.
When tightening the Bolts, tighten sequentially.
DO NOT tighten any Bolt fully and then move on to the next one.
This may cause the frame to warp.
If there are still wobbles, loosen the Bolts and execute the same drop
test.
If the Chair is not stable it could lead to damage to the product.
Attach Front Legs(C) to Seat(B) using Bolts(②), Spring Washers(④), and
Washers(⑤) with Allen Key(⑥) as pictured above.
Do not fully tighten the Bolts.
Page 4 OF 6